Mercury Outboard Logbook Service 6 - 15HP 4 Stroke Labour

Labour rate Includes (*some items do not apply to all engines):

Inspect engine for visible damage, run engine to test operation*, check engine diagnostic system for engine data/fault codes*, test engine compression rates.
Service gear housing - Drain gear housing and refill with HP gear oil, remove gear housing and service water pump, clean out passages, inspect propeller & grease prop shaft spline, lubricate drive shaft splines*, torque prop shaft nut to specification*, lubricate all grease fittings and transom clamp screws*, lubricate throttle/shift linkage pivot points*, check/replace sacrificial anodes.
Service engine - Check and inspect spark plugs and ignition components, check all accessible electrical connections, change engine oil and replace oil filter*, check battery terminals and isolation switch*, check engine/swivel mounts, remove engine deposits with power tune*, inspect fuel tank, lines and connections (where visible)*, clean or replace fuel filter and oil injection filters, check primary throttle pickups and throttle stop*, check power trim oil level, inspect thermostat and poppet valves*, inspect alternator/supercharger and timing belt(s)*, clean/replace fuel pump diaphragms*, adjust carburettor mixture and idle speed*.
Run engine and check the following items – Starting/choke operation*, Gear shift and Reverse lock operation*, Water pressure and operating temperature, test power trim system*, check all gauges, mixture and idle speed (carburettor)*, battery charging rate*.

The service rates do not include the genuine parts required which vary from engine to engine. For indicative pricing on service parts please view your engine/service kit here. Pricing does not include labour for repairs and is subject to reasonable access and condition.